ZKTeco Narrow Multi-Technology HID Proximity Card Reader (KR500H)
You may want these accessories for this product
2 Year Warranty
60 Day Guarantee
Lifetime Tech Support
Free Ground Shipping
ZKTeco's KR500H proximity card reader series is ideal for any access control scenario where you are limited to a narrow mounting surface where a standard proximity card reader would be too large and bulky. WIth the KR500H reader, you can finally take your access control to narrower spaces. Think metal doors with thin frames, parking gates, fences, turnstiles, window frames, and much more.
When it comes to compatibility, the KR500H Series has a built-in Wiegand-Out port which can be connected to almost any access control panel (including ZKAccess C3 and InBio door controllers). It's capable of reading both HID and ZKAccess 125 kHz 26-bit proximity cards.
With an IP67 weatherproof rating and tamper-resistant technology, you can rest assured that your proximity card reader is built to last. Check out the specs below to learn more about this proximity card reader.
Proximity Card Reader
This proximity card reader is capable of reading both HID and ZKAccess 125 kHz 26-bit proximity cards.
This reader's built-in Wiegand-Out port allows the reader to be used with most Access Control systems, including ZKAccess C3 and InBio door controllers.
Mullion-Size Narrow Construction
This reader has a unique narrow construction, about 1.7" wide, allowing it to fit on surfaces where space is quite limited. It's about the size of a window mullion.
IP67 Weatherproof Rating
This card reader has an Ingress Protection (IP) rating of 67. This means this proximity reader is completely protected from dust and other solid particles. It can also withstand being submerged in 3 feet of water for up to 30 minutes.
Rest assured that when you install your reader outside, it will have no problem withstanding the elements.
|Supported Card Types||HID 125 kHz (also ZKAccess)|
|Mounting||Mullions, including metal doors and window frames|
|Indoor & Outdoor Installation||Electronics sealed in weather- and tamper-resistant epoxy potting|
|LED Indicator||Red, green, amber, and off (represents 4 states)|
|Wiegand Interface||Wiegand-Out Port|
|Power Supply||5 to 16V DC|
|IP Weatherproof Rating||IP67|
|Operating Temperature||-35° F to 149° F / -40° C to + 65° C|
|Operating Humidity||20% - 80%|
|Dimensions (HxWxD)||3.2 x 1.7 x .7 inches (81 x 43 x 18 mm)|
|Certifications||FCC, ICC, CE, C-Tick, ETL Listed|
|Current Draw||35 mA typical, 75 mA peak @ 12V DC|
|Read Range||Up to 5 inches (126 mm)|
|Cabling||24 AWG minimum, multi-conductor stranded with an overall foil shield|
Verified PurchaseA nicer reader overall. The only bad part is that there is only a very small portion of the reader that reads. Takes a couple of tries to get it right.